Question: Can I Cut A 4×4 With A Circular Saw?

How long do 4×4 posts come?

The lumber industry defines standard wood post sizes as 4×4 or 6×6.

The outside dimensions of the standard 4×4 measure 3-1/2″ x 3-1/2″, and the outside dimensions of the standard 6×6 measure 5-1/2″ x 5-1/2″..

Can you turn a circular saw into a table saw?

If you’ve got a corded circular saw in good condition but is gathering dust, convert it into a table saw by building one from scratch.

How deep can a 7 1/4 inch circular saw cut?

about 2 1/2 inchesCircular Saw Sizes Standard-size saws use 7 1/4-inch blades and can cut a maximum depth of about 2 1/2 inches.

Why does my circular saw get stuck?

It could be something as simple as the spacer that goes on the nut that holds the blade on. Try tightening the blade. If the saw has a clutch it’s disengaging because there’s too much torque going to the blade. Make sure you are holding your cut items properly.

What size saw do I need to cut a 4×4?

A 12-inch miter saw will do a better job than a 10-inch miter saw. It can cut longer and thicker stocks. Regardless of whether a 12-inch miter saw is a sliding type or not, it will handle a 4×4 stock without any issues.

Can you rip with a circular saw?

In most cases, a table saw is a better choice for ripping lumber than a circular saw. But if you don’t have a table saw handy, and the rip cut doesn’t have to be precise, then a circular saw works fine. The trick is to hold the board in place while you rip it.

Will Home Depot cut 4×4 posts?

In our store, we’ll cut PT lumber no problem, as long as it fits on the saws. However, we will not do cuts like what you’re asking due to a safety issue with kickback and it getting caught in the saw. … Anything shorter than a one foot cut is a no-go for “safety” reasons.

Does Lowes cut 4×4 post?

Lowe’s can plywood, most paneling and any lumber up to a 2x. Lowe’s cannot cut 4×4, 4×6, or 6×6.

Can a 7 1 4 circular saw cut a 4×4?

Most circular saws sport a 7 ¼” blade which has a cutting depth of up to just over 2 ½” at 90 degrees and usually less when cutting bezels. The smaller 6 ½” blade cuts to a max depth of 2 1/8″. This means that the two most common blades are not large enough to go through a 4×4 in a single pass.

How long is a 4×4 piece of wood?

Actual dimensions: 3.56 in. x 3.56 in. x 96 in. No two pieces of lumber are the same.

What saw can cut a 4×4?

If you really want to cut 4x4s reliably, and if you foresee many future projects involving 4x4s, then you’re asking the wrong question. It shouldn’t be a matter of whether a 10-inch miter saw can cut a 4×4, but rather what miter saw is better suited for cutting 4x4s? The short answer is, you need a 12 inch miter saw.