Quick Answer: Are Mixer Taps A Standard Size?

What size nut is on a mixer tap?

The two most common sizes are 11mm and 13mm.

You can get them with two threaded pins that might have a 10mm nut on each.

There are a couple of odball sizes getting about but they’re usually on the cheap, tacky end of the scale..

Do all taps fit all baths?

Most baths don’t come with pre-drilled holes so you can choose any model tap that you like the style of, but make sure you check the product information if you’re buying a new bath too.

What size is a standard faucet hole?

1 3/8 inchesA standard sink faucet hole has a diameter of 1 3/8 inches, but because not all faucets are the same, some will require a 1 1/2-inch hole. It’s also important to check the depth of the sink or countertop before installing a faucet or drilling a hole.

What size fitting is a bath tap?

Bath taps generally have a 3/4″ threaded tail, and sink/basin taps 1/2″. They usually need fittings to connect to 22mm and 15mm pipes, respectively, though some bath supplies are 15mm too.

What size are bath tap back nut?

The BSP dimensions for tap back nuts or fittings are typically 1/2 inch or 3/4 inch BSP.

How do you size a nut?

If the nut is metric, count the number of lines on the tape measure to find the measurement. If you count 9 lines, the size is a 9-mm (millimeter) nut. If the nut is US standard, count the smallest lines on the tape measure in sixteenths. Add the sixteenths together to find the size.

Are tap holes a standard size?

All tap holes are standard sized at 1 3/8 inches wide, but some faucets require a 1 1/2 inch hole. Tap holes are spaced apart 4 inches on center for center set faucets, and 6 to 8 inches on center for widespread faucets.

What size are tap fittings?

For example a 3/4 inch tap connector has an actual thread diameter of approximately 1 inch. If you require a tap connector with an actual diameter of 3/4 inch you will require a 1/2 inch tap connector. The most common length of flexible tap connector is 300mm although some variations come in 150mm, 500mm and 1000mm.

How do you determine your fitting size?

Measure the Outside Diameter (OD) of your pipe or pipe fitting:Wrap a string around the pipe.Mark the point where the string touches together.Use a ruler or measuring tape to find the length between the tip of the string and the mark you made (circumference)Divide the circumference by 3.14159.

What are the 3 types of taps?

There are two types of Hand Taps:Taper Tap. A taper tap has quite a lot of taper to help it ease into cutting threads gradually. … Bottoming Tap. … Plug Tap. … Spiral Point Taps (Gun Nose or Bull Nose Taps) … Spiral Flute Taps or Gun Taps. … Interrupted Thread Tap. … Pipe Taps. … Form or Roll Taps (Thread Forming Taps)More items…

Do taps have different sizes?

The taps themselves come in various shapes and sizes but this is a fairly standard mixer design, with cold on the right and hot on the left. The water is actually mixed in the spout and not in the body.